2010 Porsche Panamera Turbo (970) V8-4.8L Turbo A L L Diagnostic Trouble Codes ( DTC ): P Code Charts Page 451

2010 Porsche Panamera Turbo (970) V8-4.8L Turbo A L L Diagnostic Trouble Codes ( DTC ): P Code Charts Page 451

- Start enable only in position P

- Limp-home message in instrument cluster

With P0603

P0603

Diagnosis information - PDK

PDK control unit, internal fault

Diagnostic conditions

The control unit initially tests internal function sequences when the ignition is switched on (terminal 15). If they are OK, all diagnosable outputs are

then tested and any faults are stored.

- Ignition on

Possible fault causes

- Control unit faulty

- Software faulty

Fault setting conditions

- Internal diagnostic routine returns fault

Fault effects

- Power supply switch-off for pressure regulator

- Solenoid valve power supply switch-off

- Hydraulic control is switched off

- Start enable only in position P

- Limp-home message in instrument cluster

Transmission Ratio Monitoring

P0603

Diagnosis information - PDK

Transmission ratio monitoring

Diagnostic conditions

The control unit initially tests internal function sequences when the ignition is switched on (terminal 15). If they are OK, all diagnosable outputs are

then tested and any faults are stored.

- Ignition on

Possible fault causes

- Speed sensors faulty

- Lines faulty

Fault setting conditions

- Rotational speed comparison of input shaft and output shaft supplies fault

Fault effects

- Limp-home message in instrument cluster

Interchange Detected

P0603

Diagnosis information - PDK

Interchange detected

Diagnostic conditions

The control unit initially tests internal function sequences when the ignition is switched on (terminal 15). If they are OK, all diagnosable outputs are

then tested and any faults are stored.

- Ignition on

Possible fault causes

- Control unit is installed in the wrong vehicle