2000 BMW 328i (E46) Technical Service Bulletin # 720299 Date: 990401
Child Seat Tether Anchor - Mounting Points
Group 72
Safety Restraint Systems
Bulletin Number
72 02 99
Woodcliff Lake, NJ
April 1999
Product Engineering
SUBJECT:
Child Seat Tether Anchor Mounting Points
MODEL:
All
Situation: Manufacturers of child restraint systems have started to provide restraint tether straps for some of their products. Customers may ask for
assistance in installing the tether anchors to the points in their vehicles described in the Owner's Manual. The following information is supplied to
assist you in locating the tether mounting points in the rear shelf area.
All current production BMW sedans, coupes, and tourings as well as certain older models, have mounting points for the tether anchors on the rear
shelf or load floor for each rear seating position. These points can be either pierced holes in the sheet metal panel or a hole with a welded 5/16-18
468
nut. The following list summarizes the applications:
Pierced Holes Welded Nuts
E30 E31
E28 E32
E39 E34
E36
E38
E46
To access each mounting point, the rear shelf trim material will have to be cut to make a hole for the fastener to pass through. On most models, the
location of the hole can be determined by pushing an awl or ice pick through the welded nut or pierced hole from inside the trunk. However, on the
E38, the rear shelf trim panel will have to be removed to determine the proper location. On E34 and E39 touring models the cargo mat will have to
be lifted to find the proper locations.
The following illustrations indicate the approximate locations of the mounting points:
Typical sedan and coupe locations.
Note:
Four passenger models do not utilize center point.
Typical touring locations
The tether anchor hardware is usually available from the child restraint system manufacturer, or their instructions will describe the fastener required
(i.e., "use a 5/16- 18 bolt of appropriate length, Grade 5 or higher").
BMW offers a 5/16-18 X 35 mm bolt for E31, E32, E34, and E36 applications, along with tether anchors, spacers, and covers. Please refer to the
EPC under "Safety Belt Rear" or "Rear Safety Belt Mounting Parts" for specific applications and part numbers. However, follow child restraint
system manufacturers instructions with regards to required mounting hardware and installation procedures.
没有评论:
发表评论