2000 BMW 328i (E46) Technical Service Bulletin # 511098 Date: 990201
Rear Bumper Cover - Poor Fit/Alignment
Group 51
Body Equipment
Bulletin Number
51 10 98
Woodcliff Lake, NJ
February 1999
Product Engineering
SUBJECT:
Rear Bumper Cover Loose
MODEL:
E46
Situation:
On some E46s the rear bumper cover may not align properly with the body in the area of the rear wheel well, and tends to stick out from the body.
344
Cause:
Temperature changes may cause the bumper cover to distort slightly.
Correction:
In case of customer complaint, an additional retainer clip, part number 5112 4015 053 can be installed to hold the bumper cover in proper alignment.
Procedure:
Remove the rear wheel and wheel house liner for access.
Using a utility knife (2) carefully trim the plasticized undercoating (3) from the lip on the quarter panel in the area immediately in front of the tab (1)
on the bumper cover. Use care to ensure that the paint does not get damaged.
Hold the bumper cover up against the body and install retaining clip (1) to hold the cover in place. The hooked end of the clip goes on the bumper
cover.
Apply a bead of Sikaflex windshield adhesive (2) over the clip and on each side of it to help hold the clip in place and provide corrosion protection.
Parts Information:
This repair requires one or two retaining clips, part number 51 12 4 015 053.
Warranty Information:
Covered under the terms of the BMW new car limited warranty.
Defect Code: 51 12 90 40 00
Parts Allowance: 51 12 4 015 053 (1 or 2 as required)
Labor Operation: 51 99 000 one side 3 FRU
没有评论:
发表评论