Interior - A-Pillar Trim Removal/Installation Procedure

2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Technical Service Bulletin # 11-013 Date: 110215

Interior - A-Pillar Trim Removal/Installation Procedure

Classification: BT11-003

Reference: NTB11-013

Date: February 15, 2011

2010 - 2011 ALTIMA; FRONT PILLAR FINISHER REMOVAL

APPLIED VEHICLE: 2010-2011 Altima Sedan (L32)

2010-2011 Altima Hybrid (L32HV)

NOTE:

Does not apply to Altima Coupe

SERVICE INFORMATION

If either one or both front pillar finishers has to be removed for any reason, refer to REPAIR PROCEDURE.

2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Page 232

SERVICE PROCEDURE

Remove Front Pillar Finisher

IMPORTANT

1. Remove the front body side welt (see Figure 1).

2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Page 233

2. Snap loose both clips by carefully prying with a suitable tool where shown in Figure 2.

CAUTION:

The lower clip will not completely snap loose. Attempting to completely snap loose by force may damage the finisher. Continue to Step 3 for proper

removal.

3. Unfasten the lower clip from the front pillar finisher (finisher) with a suitable tool. See Figure 3 and 4.

2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Page 234

4. Tip the top of the finisher inward, and then pull out (see Figure 5).

5. Remove the lower clip from the "A" pillar by pinching and then flipping upward (see Figure 6).

Re-install Front Pillar Finisher

1. Insert the lower clip on the finisher (see Figure 7).

2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Page 235

2. Re-install the finisher by inserting its locator tabs into their slots (see Figure 8 and 9).

3. Align the lower and upper clips into their slots, and then press both into place (see Figure 10).

4. Re-install the front body side welt.